Tonetuga FX Delphine Delay

Tonetuga FX Delphine Delay

Delphine is a dual modulated tape delay intended to simulate the classic tape echo machines of old. Complete with two independent delay circuits, modulation sections, and preamp sections.

The delay repeats allow a little bit of noise to flow to emulate the warmth of a vintage tape machine. Set both channels (I & II) with offsetting TIME controls to get the rhythmic repeats of a multi-head delay.

Dial in some modulation using the CHOP and WAVE controls to introduce an undulating effect, reminiscent of tape heads putting stress on the tape. This is your “Wow and flutter”.

The CHOP and WAVE can also be used as a stand-alone chorus by turning the TIME control down to 0-1. Engage both channels (I & II) in chorus mode to really fatten up your signal with overlapping choruses set with different CHOP and WAVE’s.

Each side of Delphine has an independent preamp boost (PreA). Simulating the legendary preamp found in some of the most famous tape echo units of all time. This volume lift was beloved by several guitar icons including Jimmy Page and Eddie Van Halen. While this won’t send your clean amp flying into dirty territory, it will definitely give your signal a pleasant bump.  

Each side can be individually configured, so Delphine has your back for ambient exploration, classic slapback, and organic echo repeats.

Controls:

Mix – Amount of the delay mixed into your dry signal.

Time – Range of 50-600ms Delay.

Echo – Number of repeats. Single repeats up to self-oscillation.

Chop – Speed of modulation.

Wave – Depth of Modulation.

PreA – ~10dB boost. Unity at Noon.

**100mA 9VDC Center Negative**